• Please read the Technical Data Sheet for full instructions.
• Carry out a test in an inconspicuous area.
• If you find this product is not suitable for use on your project, do not continue to use.
• Pre-clean older surfaces with Floorseal Block Paving Intensive Cleaner. 
• Once dry, treat the block & joint with Floorseal Moss Remover Plus.
• Allow to dry (we recommend 48 hours).
• Apply the sealer when rain is not likely in the next 24 hours.
• Apply the sealer via a sprayer, watering can or roller in 2 applications.
• The 1st coat should be applied liberally, soaking the block & particularly sanded joints.
• Squeegee or roller over the surface & into the joints.
• Redistribute any pooling or puddling over the surface.
• No pools or puddles should be left on the surface.
• Apply the 2nd coat (where required) two hours later.
• The sealer should be applied more sparingly and distributed over the surface.
• Squeegee or roller over the surface.
• No pooling or puddling should be noted after the product is applied.
• Do not place furniture or park cars on the surface for at least 24 hours after sealing.
• The product fully dries in approximately 4 hours but does not fully cure for 24 hours.
• This product should only be applied when air temperatures are above 10ºC and below 20ºC.
• If you wish to seal a previously sealed surface contact us for advice first.
• Do not apply to clay-based block pavers or other surfaces.
•  *Use Floorseal Algae Remover Concentrate as an ongoing cleaner.

Water-Based Block Paving Sealer

Matt finish block paving sealer

Approximately 2m2 per litre (1st coat). 5m2 per litre (2nd coat where required).

*The coverage rate will vary due to the level of porosity encountered. Pavers jointed with brush in compounds will require less product so an increased coverage rate.

For the latest guides and information on best user practices, click here.